Voodoo-lab Ground Control Pro User Manual download pdf (Page 25)

• No output: “OFF”

• Pitch Bend: “PITCHB”

• Aftertouch: “AFTERT”

•Continuous Controllers 000 through 120: “CTL007”

To choose the MIDI message type press (or press and hold) [-/NO] or [+/YES]. Some devices

let you assign controller messages to whatever parameters you like. Others will have a list of

what each controller does. You need to check the manual for the device you are controlling to

see how it works.

Tip: Controller #7 (‘CTL007’) is almost always volume.

Target Device

If you have more than one MIDI device, you must specify which one the Expression Pedal

should control. Press [CURSOR 4] to get to the following display:

Press [-/NO] and [+/YES] to select the correct device. Only those devices that you have specified

in the Device Name/Channel category of Setup mode will appear.

NAMING PRESETS

To enter the name for your new preset, press [SELECT 2] until you see:

Press [-/NO] and [+/YES] to change the characters. Press [CURSOR3 4] to move the cursor

to each character position.

Tip: To save time, if you press and hold [-/NO] or [+/YES] they will autorepeat. If you

press them both at the same time, the character is replaced by a space.

SAVING PRESETS

If you have made any changes to your preset, when you press [EDIT] to leave Edit mode, the

Ground Control Pro will display:

Press [+/YES] to save your preset. The Ground Control Pro will display briefly “SAVING TO

01”, before exiting Edit mode. If you press [-/NO] instead, you will exit Edit mode without

saving your changes. Your changes will not be lost until you select a new preset.

SAVE Y/N

"_INIT "

Target DevicePedal

P1-) DEVICE

1 2 ... 20 21 22 23 24 25 26 27 28 29 30

No comments

Voodoo-lab Ground Control Pro User Manual Page 25